ClearBlue Help and Support
Please find help for your mineral system below.
ClearBlue Mineral System
Mineral Lion Pool Ionizer
Bullion Mineral System
Common Ionizer Setup and Configuration Questions
What are the ClearBlue Ionizer settings?
Which replacement cell do I buy for my ClearBlue Ionizer?
How do I replace the ClearBlue mineral cell?
How do I use the copper test strips?
My new replacement cell has only 2 pins on the plug. There is no middle ground pin. Is this OK?
The Ionizing light is flashing red. What does that mean?
How do I make my mineral cell last longer?
I can’t get my copper level to increase to 0.2ppm
My copper level is above 0.4ppm. What should I do?
My replacement cell doesn’t fit in my tee
Should the ClearBlue controller have power all the time or go off and on with the pump?
How do I know when it’s time to change the cell?
What is the correct way to install the tee fitting?
Common Pool Ionizer Questions
How do I convert my salt water pool over to a ClearBlue mineral pool?
How do I open my ClearBlue mineral pool?
How do I install the ClearBlue Ionizer on my pool?
How do I close and winterize my ClearBlue mineral pool?
Common Spa/Hot Tub Ionizer Questions
How do I install the ClearBlue Ionizer on my hot tub?
How do I start up and maintain my ClearBlue mineral spa/hot tub?
Why does the Ionizing light alternate between red and blue?
Why is there a green/blue/turquoise ring around my hot tub?
Didn’t find an answer to your question? Please contact us.
